Printek Mt2 Betreibershandbuch

Mt2 Series Operator’s Manual Printek, Inc. 1517 Townline Road Benton Harbor, MI 49022 269-925-3200 www.printek.com Printek Part Nu

Getting Started Installing The Battery The battery compartment is conveniently located on the bottom of the printer. To install the battery, perform

Getting Started Status Indicators • The battery will be fast charged and after about 180 minutes the indicator will turn off. • Be sure to fully

Getting Started Loading the Paper Roll Attaching The Belt Loop System The belt loop system consists of two parts: • A knob located on the back p

Operation Turning On Printer Power Once the battery is charged and the paper is loaded, the printer may be powered by pressing and releasing the ON/O

Operation • Verify that the printer is turned off. • Press and hold the PAPER FEED button. • While continuing to hold the PAPER FEED button, pres

Operation Reading The Status Indicators The following table describes the information provided by the printer’s status indicators that are located on

Operation Using The Optional Magnetic Card Reader (MCR) The Magnetic Card Reader is a factory-installed option. This option requires special applicat

Printer Configuration The printer’s configuration is controlled using switches which are located in the battery compartment as shown below. Configur

Printer Configuration Note: Be careful when changing switch settings. Carefully use a pointer on the lever of the switch you wish to change. DO NOT

Printer Configuration Infrared (IrDA) Interface Configuration In order for the printer to receive data using the IrDA interface, configuration switch

FCC Part 15 Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Printer Configuration Programming Information This section provides a summary of the printer commands support by the Mt2 Series printers. For complet

Printer Configuration Printer Font Commands – Courier Character Set Command String Printer Action ESC k 5 Selects 24 CPI Normal Font (8x12) ESC k 4

Printer Configuration Magnetic Card Reader Control Commands Command String Printer Action ESC M nn track CR Enable MCR with nn auto timeout to read

Printer Configuration Resident Character Sets The following tables show the symbols for character values 32 through 255 (decimal). These character s

Printer Maintenance Cleaning In normal environments, the printer should be cleaned after printing a few rolls of paper or if there are voids in the p

Printer Maintenance Battery Maintenance Charging The printer’s battery is charged in the printer using an optional power adapter. Power adapters are

Printer Maintenance • Verify that the printer’s amber CHARGING INDICATOR is illuminated. If so, the charger circuit is functioning properly. • Afte

Troubleshooting Please review the following table to solve common problems you may encounter with your printer. You may also visit www.printek.com f

Read all setup and operating instructions before proceeding with operation. Do not operate in an enclosure unless properly ventilated. Make sure n

Specifications Printer Specifications Printing Specifications Printing Method: Direct thermal Printing Resolution: 384 dpi (8 dots per mm) Pri

Specifications Operator Controls and Indicators Status Indicators: 3 LEDS (2 multi-functioning) – Power/Lo Bat., Charging, Fault/MCR Ready User S

Specifications Printer Supplies and Accessories Part Number Description

Glossary of Terms ASCII American Standard Code for Information Interchange. authentication The process a Wi-Fi station uses to identify itself to a

TABLE OF CONTENTS Introduction ...

Introduction Thank you for purchasing a Printek Mt2 Series Mobile Printer. The Mt2 printers have been designed to provide you years of service, hand

Getting Started The Mt2 and Mt2B mobile printers are full featured portable receipt printers designed for varied job environments including field ser