Printek FormsMaster 8003se Betreibershandbuch PDF herunterladen (Seite 105)

Using the Optional Setup Module

Introduction

The optional Setup Module is a small cartridge that plugs directly into the

RS-232 Serial connector on the rear of any FormsMaster 8000 series

printer. This module is used to store a second copy of the current Setup

configuration of the printer. This may then be used to restore settings after

a printer is serviced or to copy the same configuration settings to another

printer. These uses are discussed immediately following the installation

instructions.

Setup Module Installation

To install the Setup Module, perform the following steps.

1. Turn off power to the printer.

2. Disconnect the cable plugged into the serial port if one is present.

3. Plug the Setup Module into the serial port.

4. If a cable was present in step 2, reconnect it to the connector on the

rear of the Setup Module.

5. Turn on power to the printer.

6. If this is not the first time the Setup Module has been connected to a

printer, the printer will proceed with step 7.

If this is the first time the Setup Module has ever been attached to a

printer, the printer will temporarily display the following message

and the ONLINE indicator will be yellow. When the message

disappears, installation is complete and the printer will continue with

its normal power up procedure.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 136 137

Keine Kommentare

Printek FormsMaster 8003se Betreibershandbuch Seite 105