Printek FormsMaster 8003se Betreibershandbuch PDF herunterladen (Seite 106)

USING THE OPTIONAL SETUP MODULE

100

Initializing

Setup Module

7. The printer will now compare the configuration data in its internal

memory to the data in the Setup Module. If the data are not an exact

match, the printer will proceed with step 8.

If the data in the printer and the data in the module are an exact

match, installation is complete and the printer will complete its

power up procedure.

8. The printer has now determined that the data in the Setup Module

does not exactly match the data in the printer’s internal memory. The

printer will now display the following message, the ONLINE indicator

will flash yellow and the bell will beep to get the operator’s attention.

Proceed to step 9.

New Setup

Module Detected

9. Press the ONLINE button. The printer will now stop flashing the

ONLINE indicator (will remain yellow) and display the following

message. You must now make one of the selections as described

below.

←Copy to Printer

←Copy to Module

If you wish to copy the Setup data to the printer from the Setup

Module, press the button indicated by the arrow next to

Copy to

Printer (the SETUP button). The printer will display the following

message and will now be configured according to the information

that was in the Setup Module.

Copying Setup

to Printer

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 136 137

Keine Kommentare

Printek FormsMaster 8003se Betreibershandbuch Seite 106