Printek FormsMaster 8003se Betreibershandbuch PDF herunterladen (Seite 89)

PRINTER CONFIGURATION

Off

Possible Values: Off*, Barber Pole, Hex Dump,

Remote Setup, Demos

When this item is set to

Barber Pole, the printer will print a rotating

character pattern. Printing may be started and stopped with the ONLINE

button.

When set to

Hex Dump, the printer will print all received data in a special

debug format which may be used by programmers to solve software

problems. For more information, refer to the Hex Dump section of the

FormsMaster 8000 series Programmer’s Manual.

When set to

Remote Setup, the printer is ready to receive a configuration

setup file. See “Using Remote Setup” on page 91.

When set to

Demos the printer will enter a special demonstration mode. For

more information, refer to “Using the Built In Demos” below.

Using the Built In Demos

The demonstration mode, or “Demos” is a feature used by sales people to

demonstrate the FormsMaster printer’s capabilities. Printed instructions for

the Demo mode may be requested by performing the following steps.

1. Enter the Setup Test Menu and set the

Test Mode to Demos as

described above, and then press ONLINE to exit Setup.

2. After the printer has finished resetting, take the printer off line and

press either of the ITEM buttons until

About the Demos is

displayed

3. Press either of the VALUE buttons until

Overview is displayed.

4. Press ONLINE to begin printing the Demo Overview.

5. Repeat step 3 and then press either of the VALUE buttons until

Tips is

displayed.

6. Press ONLINE to begin printing the Demo Tips.

Review these two pages to print the desired demos. Remember that while

the printer is in Demo mode, it will not accept any data from any of the host

interface ports.

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 136 137

Keine Kommentare

Printek FormsMaster 8003se Betreibershandbuch Seite 89