Printek FormsMaster 8003se Betreibershandbuch PDF herunterladen (Seite 108)

USING THE OPTIONAL SETUP MODULE

102

Using the Setup Module to

Copy Setup Data From One Printer to Another

This use of the Setup Module is beneficial when installing or updating

several printers that need to be configured exactly the same. To do this, you

will need to perform the installation procedure once for each printer.

First, install the Setup Module on the printer where the Setup data is to be

copied from. If the printer determines that steps 8 and 9 are required,

choose “Copy to Module” in step 9 and allow the printer’s power up

procedures to complete. If any additional changes need to be made to the

configuration of this printer, enter Setup and make them before removing

the Setup Module. Any changes made will automatically be stored both in

the printer’s internal memory and the Setup Module.

You may now power off the printer and remove the Setup Module.

Remember to reconnect the serial cable if one was attached.

Now perform the installation procedure on each of the printers that are to be

configured the same as the first. In step 9 be sure to choose “Copy to

Printer”. After the Setup Module is removed, remember to reconnect the

serial cable if one was attached.

A Special Note Regarding Optional Interfaces

The Setup Module stores all the items which can be configured using Setup

as described in “Printer Configuration” beginning on page 39 or “Using

Remote Setup” on page 91. This includes the parameters for all of the

optional interfaces, even if they are not installed.

This is not typically a problem since all the printers in an installation are

typically configured with the same interfaces, but in cases where printers

have different interfaces, it is important to understand what could happen.

When using the Setup Module to copy from a printer with no optional

interface installed, it will just copy the default settings for all of the

interfaces. This is only a problem if the printer being copied to does have

one of these interfaces installed, because items previously set will be set

back to the default values in the original printer. A similar situation might

exist when copying between printers that have different optional interfaces

installed.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 136 137

Keine Kommentare

Printek FormsMaster 8003se Betreibershandbuch Seite 108